If you want to Auto Connect to your favorite server on Liquid Viscosity its just a few basic steps!


 1.   Right Click Liquid Viscosity System Tray icon and go to Preferences.
Right Click Viscosity System Tray icon and go to Preferences



 2.   Right Click the server you wish to Auto Connect to and go to Edit.
Right Click Desired Server Click Edit



 3.   
In the Bottom left corner you should see Connect when Liquid Viscosity opens, you want that checked, then Click save.
Connect when Liquid Viscosity opens is checked.



 4.  
After saving your going to want to just double check to make sure in the General tab that "Start Liquid Viscosity at Login" is checked.  It is on by default in newer installations, but older / updated from older it is not defaulted on.
Making sure start Liquid Viscosity at Login is turned on in general tab




 5.   
In Four steps we Auto Connect to a server, at startup!  Next time you put it should auto login to your server that you edited!

Also Read

How to Import VPN Connections On Viscosity
In this guide we will be importing .ovpn or .visz connections into Liquid Viscosity on Windows....
Installing Viscosity on Windows Xp
Please note AVG users may experience a problem when running Liquid Viscosity. Until AVG releases...
Start Program on Connect, Kill Program on Disconnect
In this guide we will be setting up firefox to open when the desired VPN is connected and close...
How to connect to a VPN server
1. Run the software either from the Desktop icon or by locating it through the start menu...
Installing Viscosity on Windows 7
Please note AVG users may experience a problem when running Viscosity. Until AVG releases an...