If you want to Auto Connect to your favorite server on Liquid Viscosity its just a few basic steps!


 1.   Right Click Liquid Viscosity System Tray icon and go to Preferences.
Right Click Viscosity System Tray icon and go to Preferences



 2.   Right Click the server you wish to Auto Connect to and go to Edit.
Right Click Desired Server Click Edit



 3.   
In the Bottom left corner you should see Connect when Liquid Viscosity opens, you want that checked, then Click save.
Connect when Liquid Viscosity opens is checked.



 4.  
After saving your going to want to just double check to make sure in the General tab that "Start Liquid Viscosity at Login" is checked.  It is on by default in newer installations, but older / updated from older it is not defaulted on.
Making sure start Liquid Viscosity at Login is turned on in general tab




 5.   
In Four steps we Auto Connect to a server, at startup!  Next time you put it should auto login to your server that you edited!

Also Read

Liquid Viscosity Enable/Disable LiquidDNS
By Default DNS leak protection is turned on. To Toggle DNS leak protection off/on follow these...
How to connect to a VPN server
1. Run the software either from the Desktop icon or by locating it through the start menu...
Start Program on Connect, Kill Program on Disconnect
In this guide we will be setting up firefox to open when the desired VPN is connected and close...
Liquid Viscosity on OS X
Please note that Liquid Viscosity is outdated and is no longer the recommended way to connect to...
Generate new Liquid Viscosity License
When installing Liquid Viscosity if you get an error about your license file not being valid you...